Insertion Point [EX1-CUG]

Please follow the instructions provided below to add the insertion points where the bearings will be created.

1	Navigate to Bridge Geometry > Insertion Point
2	To create the first insertion point, click on the three-dot icon located on the first cell of the Location. And click “Select”
3	From the combobox menu, choose the "SL1" support line for the End Bent location.
4	For each support line, there should be one insertion point positioned beneath each "Concrete U Girder". Since there are two "Concrete U Girder" in the project, there will be two insertion points located on each support line.
5	Enter Transverse Offset as -12 and +12 to relocate the insertion points on the support line
6	Repeat the same to create other insertion points and set their transverse offset values
7

1	Navigate to Insertion Point under Bridge Geometry.
2	Copy Bridge Parameters from model inputs and paste into OpenBrIM.

Insertion point layout is given below.

Insertion Point

Insertion Point
Bridge Parameters
`IP1 SL1 0.00 -14.00 IP2 SL1 0.00 14.00 IP3 SL2 0.00 -14.00 IP4 SL2 0.00 14.00 IP5 SL3 0.00 -14.00 IP6 SL3 0.00 14.00 IP7 SL4 0.00 -14.00 IP8 SL4 0.00 14.00`

OpenBrIM