Insertion Point [EX1-PIG]
- mert.goktas (Unlicensed)
- Cagin Yakar
Please follow the instructions provided below to add the insertion points where the bearings will be created.
Navigate to Bridge Geometry > Insertion Point |  |
Click the three-dots on the first cell of the Location and create the first insertion point by setting its location to Abut1 | |
Each bearing must have a minimum of one insertion point. Additionally, for each precast girder, there should be one insertion point at the beginning and one at the end.
| 
|
Repeat the same to create other insertion points and set their transverse offset values | |
Skew angle and transverse offset parameters for support lines that have skew > 0. User need to enter T value for skewed supports.
Skew angle and longitudinal offset parameters for support lines that have skew > 0.
| |
| 1 | Navigate to Insertion Point under Bridge Geometry. |
| 2 | Copy Bridge Parameters from model inputs and paste into OpenBrIM. |
Insertion point layout is given below.
|
Insertion Point |
|---|
Bridge Parameters |
IP1 Abut1 1.0000 -11.0000
IP2 Abut1 1.0000 -3.5000
IP3 Abut1 1.0000 4.5000
IP4 Abut1 1.0000 12.0000
IP5 Abut1 1.0000 20.0000
IP6 Pier1 -1.0000 -11.0000
IP7 Pier1 -1.0000 -3.5000
IP8 Pier1 -1.0000 4.5000
IP9 Pier1 -1.0000 12.0000
IP10 Pier1 -1.0000 20.0000
IP11 Pier1 1.0000 -11.0000
IP12 Pier1 1.0000 -6.0000
IP13 Pier1 1.0000 -1.0000
IP14 Pier1 1.0000 4.5000
IP15 Pier1 1.0000 10.0000
IP16 Pier1 1.0000 15.0000
IP17 Pier1 1.0000 20.0000
IP18 Pier2 -1.0000 -11.0000
IP19 Pier2 -1.0000 -6.0000
IP20 Pier2 -1.0000 -1.0000
IP21 Pier2 -1.0000 4.5000
IP22 Pier2 -1.0000 10.0000
IP23 Pier2 -1.0000 15.0000
IP24 Pier2 -1.0000 20.0000
IP25 Pier2 1.0000 -11.0000
IP26 Pier2 1.0000 -3.5000
IP27 Pier2 1.0000 4.5000
IP28 Pier2 1.0000 12.0000
IP29 Pier2 1.0000 20.0000
IP30 Abut2 -1.0000 -11.0000
IP31 Abut2 -1.0000 -3.0000
IP32 Abut2 -1.0000 5.0000
IP33 Abut2 -1.0000 12.5000
IP34 Abut2 -1.0000 20.0000 |