Support Lines [EX1-CUG]
- mert.goktas (Unlicensed)
Please follow the instructions provided below to define the reference support lines where the Piers/Bents will be located.
| 1 | Navigate to Bridge Geometry > Support Lines |  |
| 2 | To create the support line at Station 0 ft for the Bridge, Click on the three-dot icon located on the first cell of the Bridge and set it to "Bridge1". | |
| 3 | Follow the same process to create the support lines for the remaining structures at their respective stations. Set the support line for Pier1 at Station 150 ft, Pier2 at Station 300 ft, and Abut2 at Station 450 ft. |
 |
| 4 | The support lines that have been established thus far are designated for the locations of End Bent and Pier CAP. Now, proceed to input the necessary locations for "Temporary Support" in order to sequentially assembly the Girder Segments. |
|
| 5 | Please enter the names and stations of all Temporary Supports as depicted in the figure. | |
| 6 | The support lines do not exhibit any Skew Angles and Transverse Offset |
|
Navigate to Support Lines under Bridge Geometry. |
Copy Bridge Parameters from model inputs and paste into OpenBrIM. |
Completed Support Lines are illustrated below.
Support Lines |
|---|
Bridge Parameters |
SL1 BRG1 0.00 0.00 0.00
SL2 BRG1 150.00 0.00 0.00
SL3 BRG1 300.00 0.00 0.00
SL4 BRG1 450.00 0.00 0.00
TemporarySup1 BRG1 20.00 0.00 0.00
TemporarySup2 BRG1 99.00 0.00 0.00
TemporarySup3 BRG1 101.00 0.00 0.00
TemporarySup4 BRG1 199.00 0.00 0.00
TemporarySup5 BRG1 201.00 0.00 0.00
TemporarySup6 BRG1 249.00 0.00 0.00
TemporarySup7 BRG1 251.00 0.00 0.00
TemporarySup8 BRG1 349.00 0.00 0.00
TemporarySup9 BRG1 351.00 0.00 0.00
TemporarySup10 BRG1 430.00 0.00 0.00 |