Surface Load [EX1-STG]
- mert.goktas (Unlicensed)
Please follow the instructions provided below to add surface and the corresponding load definitions.
| 1 | Navigate to Load Geometry Definitions > Surface > Quadrilateral |  |
| 2 | Click three-dots icon on Bridge cell and set “BRG1”. | |
| 3 | Enter Start Station, End Station and Surface Width data as follows for LS1 (Load Surface Definitions).
| 
|
| 4 | Navigate to Loads > Surface Load |
|
| 5 | Click on the three-dots icon in the surface cell, and set LS1 to identify the construction stages that have a surface load. | |
| 6 | As per the construction stages in the project, you should define 3 surface loads. Then enter the name. | |
| 7 | Click three-dots icon on Stage cell and click select. Enter the stage data as follows:
|
|
| 8 | Enter the magnitudes of the (Surface) Loads to be applied on Surface as in the figure.
| |
| 9 | In this cell, set the Element's stage, which indicates which surface load will be applied to each surface. |
| 1 | Go to Quadrilateral under Load Geometry Definitions on the tree view. |
| 2 | Copy Surface, and Graphics from model inputs and paste into OpenBrIM. |
| 3 | Go to Surface Load under Loads on the tree view. |
| 4 | Copy General from model inputs and paste into OpenBrIM. |
Quadrilateral | |
|---|---|
Surface | Graphics |
LS1 BRG1 0 520 0 0 36 0 0 | LS1 0 Alignment
|
Surface Load |
|---|
General |
FutureWearLoad LS1 FutureWearingStage 0 0 0.03 0 0 0 Deck
SIPLoadLeft LS1 SIPFormworkStage 0 0 0.015 0 0 0 Girder Top Left Flange
SIPLoadRight LS1 SIPFormworkStage 0 0 0.015 0 0 0 Girder Top Right Flange |