Girder Camber Diagram and Fabrication Model [EX1-STG]

Camber diagram is used in construction, which indicates the specified camber at all points along the length of a truss or beam.

When constructing a structure, such as a bridge, fabrication models should be created that take into account displacements made along a line and their corresponding opposite shifts.

This section will cover to create the Camber Diagram and Fabrication Model Report by making the required assignments.

Navigate to Reports > Girder Camber Diagram and Fabrication Model

Set Girder under Girder Column to create Camber Diagram and Fabrication report.

Set Girder as G1.

Navigate Deflection Results Cases tab.

Click three-dots icon on Steel Dead Load and click select.

Select TubGirderDL in the combobox.

Repeat the same steps from 4 to 5 for Non-Composite Dead Load and Composite Dead Load.

Enter data as follows:

• Non-Composite Dead Load: DeckDL

• Composite Dead Load: DC2

Navigate to Girder Camber Diagram and Fabrication Model under Reports on the tree view.

Copy General and Deflection Result Cases from model inputs and paste into OpenBrIM.