Concrete Girder Load Rating [PIG]

General

Load Rating Template: This parameter can be used to assign a previously generated Load Rating Template.

Girder: This parameter can be used to specify the girder for which the load rating will be processed accordingly.

Station: Specify the station for which the load rating will be performed.

Design Section w Rebars (or Tendons) [Section from 3D/Override Section (Non-Composite)/Override Section (Composite)]:

Override Design Section: If the "Design Section w Rebars (or Tendons)" parameter is specified with an option other than "Section from 3D," this parameter can be used to specify the section to be overridden. The section to be used for load rating can either be imported or chosen from previously defined ones under Properties > Sections.

Stages for Stress Checks:

• Stage: Specify a stage to be used for stress checks.

• Loss Computation Time Frame [Segment Erection/Between Transfer and Deck Placement/After Deck Placement]:

Station: This parameter can be used to specify the station at which the code check will be performed.

Relative Position (readonly): The relative position of the code check station, based on the total length of the girder, will be presented to the user.

Effective Web Width:

Shear Reinforcements

Shear Reinforcement Data [Use Girder’s Rebar Data/ Override Rebar Data]: Users can specify whether to use the rebar data previously defined in the girder object or to override the shear reinforcement data with the parameters below for use in code checks.

Rebar Profile: If the shear reinforcement data is to be overridden, the rebar profile can be specified using this parameter.

Rebar Spacing: This parameter can be used to specify the spacing between rebar elements.

Number of Legs: This parameter can be used to define the number of rebar legs in the shear reinforcement.

Transverse Rebar Material: This parameter can be used to specify the material used for the shear reinforcement.