Girder Layout [EX1-PIG]
- mert.goktas (Unlicensed)
- Cagin Yakar
Please follow the instructions provided below to create girder line layouts.
Navigate to Bridge Geometry > Girder Layout | 
 |
Click three-dots on the first cell of the Supports and pick the insertion points IP1, IP6 | |
Follow the same process to set all Girder Layouts | |
This gif illustrates the process of creating the “Girder Layout”.
| |
Enter the Initial & End Cantilever Length of Girder and values as 6.5 The Cantileverlength parameter represents the distance between the bearing and girder end. This distance is included in the self-weight computation of the girder. |
|
| 1 | Navigate to Girder Layout under Bridge Geometry. | |
| 2 | Copy Layout from model inputs and paste into OpenBrIM. | |
Girder layout is given below.
Girder Layout |
|---|
Layout |
GL1 [IP1,IP6] 6.5 6.5
GL2 [IP2,IP7] 6.5 6.5
GL3 [IP3,IP8] 6.5 6.5
GL4 [IP4,IP9] 6.5 6.5
GL5 [IP5,IP10] 6.5 6.5
GL6 [IP11,IP18] 6.5 6.5
GL7 [IP12,IP19] 6.5 6.5
GL8 [IP13,IP20] 6.5 6.5
GL9 [IP14,IP21] 6.5 6.5
GL10 [IP15,IP22] 6.5 6.5
GL11 [IP16,IP23] 6.5 6.5
GL12 [IP17,IP24] 6.5 6.5
GL13 [IP25,IP30] 6.5 6.5
GL14 [IP26,IP31] 6.5 6.5
GL15 [IP27,IP32] 6.5 6.5
GL16 [IP28,IP33] 6.5 6.5
GL17 [IP29,IP34] 6.5 6.5 |