2.3 Slab Analysis Results
- mert.goktas (Unlicensed)
Please follow below instruction to see the Slab Analysis Results
Table 1: Slab Analysis Results
| 1 | Navigate to the "Slab Results" section under "Analysis Result" in the tree view. This section will allow you to check if any changes have been made for each floor in the spreadsheet that you have previously viewed. | 
|
| 2 | Navigate to the "1st Floor" section under "Slab Results". Once you have reached this section, please select "Safe" as the analysis result. Then, select the type and direction of the value you would like to see as a result. After that the result will be displayed on the CAD side. | 
|
| 3 | Analysis Source: Safe → Direction: Both → Type: Top Area  Display of results in CAD view
| |
| 4 | Select "AECBolt" as the analysis result. Then, select the result case, type and direction of the value you would like to see as a result. After that the result will be displayed on the CAD side. | 
|
| 5 | Analysis Source: Aecbolt → Direction: 1 → Result Case: 1.2D+1.6L → Type: Mz 
| |
The Slab Analysis Results part is completed in this step.
You can proceed to the “Slab Design” section.