Quadrilateral [EX1-PIG]
- mert.goktas (Unlicensed)
Please follow the instructions provided below add to the corresponding load definitions.
| 1 | Navigate to Load Geometry Definitions > Surface > Quadrilateral |  |
| 2 | Click three-dots icon on Bridge cell and set “Bridge1”. | |
| 3 | Set the name as Span1DeckSurface
Enter Start Station, End Station and Surface Width data as in the figure for Span1DeckSurface (Load Surface Definitions). |
 |
| 4 | Keep the default data in the Graphics section constant. | |
| 5 | As there are 3 spans in the project, it is necessary to define 3 different surface loads.
|
| 1 | Navigate to Quadrilateral under Load Geometry Definitions on the tree view. |
| 2 | Copy Surface, and Graphics from model inputs and paste into OpenBrIM. |
Quadrilateral | |
|---|---|
Surface | Graphics |
Span1DeckSurface Bridge1 23846.1200 23897.3200 -18.0000 -18.0000 14.0000 5.7800 5.2800
Span2DeckSurface Bridge1 23897.3200 23982.2800 -18.0000 -18.1200 14.0000 5.2800 10.1200
Span3DeckSurface Bridge1 23982.2800 24026.8400 -18.1200 -18.0000 14.4000 10.1200 14.6800 | Span1DeckSurface 0.0000 Alignment
Span2DeckSurface 0.0000 Alignment
Span3DeckSurface 0.0000 Alignment
|