Girder Layout [EX1-STG]

Please follow the instructions provided below to create girder line layouts.

1	Navigate to Bridge Geometry > Girder Layout
2	To select the insertion points for define Girder Layout , click on the three-dot icon located on the first cell of the Supports and pick IP1, IP3, IP5, and IP7.
3	Click Done after the selection of the insertion points. And then to define another Girder Layout, select insertion points IP2, IP4, IP6, and IP8.
4	Set Type as curved.

1	Navigate to Girder Layout under Bridge Geometry.
2	Copy Layout from model inputs and paste into OpenBrIM.

Girder layout is given below.

	Girder Layout

	Girder Layout
1	Layout
2	`GL1 [IP1,IP3,IP5,IP7] Curved 0 0 GL2 [IP2,IP4,IP6,IP8] Curved 0 0`

OpenBrIM