Concrete Deck [EX1-CUG]

Please follow the instructions provided below to define Concrete Deck.

1	Navigate to Deck > Concrete Deck.
2	Click on the "Girders" column. Click “pick” from the combobox. Select the girders graphically you want to create a deck.
3	Click on the three-dot icon located on the first cell of the Cross-Section and click “Edit”
4	Click on the three-dot icon located on the first cell of the “Cross Section Location” Then designate the locations for the “Cross-Sections” data. Associate a "Cross Section" with each "support line." This assignment will result in a specific deck cross-section being established between the two selected support lines. In cases where the "Cross Section" changes between two support lines, the "Variation w/Next Segment" parameter is employed to define the attributes of the transitions between the sections.
5
6	Navigate back to General spreadsheet.
7	Set Material type as Fc_5ksi.
8	Click on the three-dot icon located on the first cell of the Deck Reinforcement Data and click “Edit”
9	Enter the Deck Reinforcement Data as in the figure. After completing this step, the reinforcement process for the "Deck1" deck will be finished.

1	Navigate to Concrete Deck under Deck on the tree view.
2	Copy General and 3D Settings from model inputs and paste into OpenBrIM.

The Concrete Deck that have been created are illustrated below.

Concrete Deck

Concrete Deck
General	3D Settings
`Deck1 [[SL1, 0, CS1, 0, 1],[SL4, 0, CS1, 0, 1]] [CUG1,CUG2] YES NO NO Fc_5ksi [[0, 5400, A615_60, 4, 4, ASTMA615No9, ASTMA615No9, 2, 2, 1]]`	`Deck1 4.0000`

Section Data

Section Data
Cross-Sections	Girders	Deck Reinforcement Data
`[[SL1, 0, DCS1, 0, 1],[SL4, 0, DCS1, 0, 2]]`

OpenBrIM