...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to define construction of substructure bridge components. |
...
...
Deck pouring and hardening are the states of deck construction stage and should be specified here.
...
Go to Deck Casting tab.
...
...
Specify names of the deck construction stages in Name.
...
Select pouring stages in Pouring Stage (Weight Only) and hardening stages in Hardening Stage (Gains Stiffness).
...
...
Go to Deck under Superstructure on the tree view.
...
Copy Deck Casting, Longitudinal and Transverse from model inputs and paste into OpenBrIM.
...
Go to Girder Erection (Complete) under Superstructure on the tree view.
...
Copy Girder Construction from model inputs and paste into OpenBrIM.
...
Go to Superstructure Attachment Construction under Superstructure on the tree view.
...
Copy General from model inputs and paste into OpenBrIM.
...
Bearing
...
Superstructure Connection Construction
| Code Block |
|---|
SCC1 GirderStage [IP8,IP7,IP6,IP5,IP4,IP3,IP2,IP1,IP12,IP11,IP10,IP9,IP16,IP15,IP14,IP13] |
...
Pier Cap/End Bent (Complete)
...
Pier Cap Construction
| Code Block |
|---|
PCC1 SubstrConstStage [PierCap1,PierCap2] 1 |
...
Pier Column
...
Pier Column Construction
| Code Block |
|---|
PCC2 SubstrConstStage [PierColumn1,PierColumn2,PierColumn3,PierColumn4,PierColumn5] 1 |
...
Foundation (Complete)
...
Foundation Construction
| Code Block |
|---|
FC1 SubstrConstStage [Footing1,Footing2] 1 |
...
Pile
Pile Construction
...
| Info |
|---|
After clicking on ‘Construction> Substructure Construction> Bearing Construction' in the navigation treeview, follow the steps to define the Bearing Construction. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Bearing Construction [SIG] |
| 1 | 🖱️ Click three-dots icon on Stage cell and select a Construction Stage as GirderStage. |    | ||||||||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the insertion points are define in the next step. |  | ||||||||||
| 3 |
| |||||||||||
| 4 | 🖱️ Click three-dots on the cell of the Insertion Points and pick all the insertion points. |    | ||||||||||
| 5 | Proceed to the next step to verify the model. | |||||||||||
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed bearing construction is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...