...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to define construction of substructure bridge components. |
...
...
Select a Stage at Superstructure Connection Construction tab as GirderStage.
...
...
Pick Insertion Points.
...
...
Click all the Insertion Points.
...
...
| Info |
|---|
After clicking on ‘Construction> Substructure Construction> Bearing Construction' in the navigation treeview, follow the steps to define the Bearing Construction. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Bearing Construction [SIG] |
| 1 |
|    | ||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the insertion points are define in the next step. |  | ||||
| 3 |
| |||||
...
| |||||
...
| ||||
...
| |||||
Go to Bearing under Substructure Construction on the tree view.
| 4 |
|    |
| 5 | Proceed to the next step to verify the model. | |
| Anchor |
|---|
...
|
...
|
...
Bearing
Superstructure Connection Construction
...
| Tip |
|---|
The completed bearing construction is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...