...
| 1 | Navigate to Properties > Sections |  | |
| 2 | To import a section, click on the three-dot icon located on the first cell of the Name and select "Import Section". | ||
| 3 | Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U78G5 Assign Material as: Fc_6ksi Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U54G5 Assign Material as: Fc_6ksi |  | |
| 4 | Select OpenBrIM Bridge Objects > Basic Sections > Basic Shapes > Circle | 
| |
| 5 | Enter Width & Depth as 42 in import section editor. Then Click Import | ||
| 6 | Assign Material as Fc_5ksi (If the material Fc_5ksi is already assigned by default, there is no need to assign it again) | ||
| 7 | Rename this section as EBSec | ||
| 8 | Repeat the same steps from 4 to 7 for the other basic section. Enter Witdh and Depth
Rename this section as PCSec Assign Material as Fc_5ksi |  | |
| 9 | Repeat the same steps from 4 to 7 for the other basic section.
Rename this section as ColSec Assign Material as Fc_6ksi |  | |
| 10 | Repeat the same steps from 4 to 7 for the other basic section. Enter Witdh and Depth
Rename this section as PileSec Assign Material as Fc_4ksi |  | |
| 11 | Create a new section by defining its name as RigidSection |
| |
| 12 | Copy and pastethe data below.
Refer to following page for more information about how to define Rigid Section |
...
| Tip |
|---|
Completed Sections definitions are illustrated below. |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
...
Step 2: Adding Rebars and Strands to the Section
This step involves providing details of the rebars in the section.
| Info |
|---|
Please follow the instructions provided below to set rebar detailing for U78G5 |
| 1 | From any cell of the U78G5 row, click on three-dots icon to open Section Editor panel. |  |
| 2 | Click + icon at the left top side of the screen. And Select Rebar | |
| 3 | Enter:
Click Add. |  |
| 4 |  |
...
| Info |
|---|
Please follow the instructions provided below to set rebar detailing for U54G5 |
| 1 | From any cell of the U54G5 row, click on three-dots icon to open Section Editor panel. | |
| 2 | Click + icon at the left top side of the screen. And Select Rebar | |
| 3 | Enter:
Click Add. | |
| 4 |