Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 2 Next »

This part is to inform about the general purposes of section definitions.

Please follow the instructions provided below to set section definitions to be used in this bridge example.

Step 1: Adding Sections to the Project

1

Navigate to Properties > Sections

2

To import a section, click on the three-dot icon located on the first cell of the Name and select "Import Section".

3

Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U78G5

Assign Material as: Fc_6ksi

Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U54G5

Assign Material as: Fc_6ksi

4

Select OpenBrIM Bridge Objects > Basic Sections > Basic Shapes > Circle

5

Enter Width & Depth as 42 in import section editor.

Then Click Import

6

Assign Material as Fc_5ksi

(If the material Fc_5ksi is already assigned by default, there is no need to assign it again)

7

Rename this section as EBSec

8

Repeat the same steps from 4 to 7 for the other basic section.

Enter Witdh and Depth

  • Width: 36

  • Depth: 36

Rename this section as PCSec

Assign Material as Fc_5ksi

9

Repeat the same steps from 4 to 7 for the other basic section.

  • Radius: 18

Rename this section as ColSec

Assign Material as Fc_6ksi

10

Repeat the same steps from 4 to 7 for the other basic section.

Enter Witdh and Depth

  • Width: 12

  • Depth: 12

Rename this section as PileSec

Assign Material as Fc_4ksi

  • No labels