Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 3 Next »

Footing Point Load

Footing: Specify the footing to which the load will be applied.

Stage: Choose the stage at which to apply the load.

Specify Position As[Point/Column Center]: If the Point input method is selected, the engineer must specify a position relative to the footing center. If Column Center is selected, the engineer must specify a column. The load will then be positioned at the center of the specified column.

X Position (Center is (0,0)): This input is enabled if Specify Position As is set to Point. Enter the X-coordinate of the point load relative to the footing center.

Y Position (Center is (0,0)): This input is enabled if Specify Position As is set to Point. Enter the Y-coordinate of the point load relative to the footing center.

Column: This input is enabled if Specify Position As is set to Column Center. Specify the column. The load will be positioned at the column's center, where it connects to the footing.

Fx: Force in the longitudinal direction along the PGL.

Fy: Force in the direction perpendicular to the PGL.

Fz (Gravity): Force in the vertical direction. A positive value indicates a load in the global -Z or gravity direction. For usual loads (wearing surface loads - stay-in-place formwork loads), the user should input positive values.

Mx: Moment in the longitudinal direction along the PGL.

My: Moment in the direction perpendicular to the PGL.

Mz: Moment in the vertical direction.

  • No labels