This section starts with a load geometry definition (surface) and proceeds with the corresponding load (surface load).
Follow the next steps to add surface and the corresponding load definitions.
| 1 | Go to Load Geometry Definitions/ Surface/Quadrilateral in tree view. |  |
| 2 | Select Bridge. | |
| 3 | Specify Start Station, End Station and Surface Width. |  |
| 4 | Go to Loads/Surface Load. |  |
| 5 | Name surface load and select Surface. | |
| 6 | Enter Magnitude (Gravity) of the surface load. |  |
| 7 | Specify Stage and Element (of which surface load to be applied). |
Follow the below steps to copy and paste all inputs from our data set.
| 1 | Go to Quadrilateral under Load Geometry Definitions on the tree view. |
| 2 | Copy Surface, and Graphics from model inputs and paste into OpenBrIM. |
| 3 | Go to Surface Load under Loads on the tree view. |
| 4 | Copy General from model inputs and paste into OpenBrIM. |
Copy the desired data with the automatic copy button in the upper left corner. Click on the first cell in and use the Ctrl+V shortcut to paste.  
If icon won’t appear, collapse page tree menu by clicking on arrow or using shortcut “[”.  While pasting large data, it would be handy to turn of Auto-refresh . 
|
Quadrilateral | |||||
|---|---|---|---|---|---|
Surface LS1 BRG1 0.0000 530.0000 0.0000 0.0000 36.0000 0.0000 0.0000 | Graphics LS1 0.0000 Alignment | ||||
Surface Load |
|---|
General FutureWearLoad LS1 FutureWearingStage 0.0000 0.0000 0.0300 0.0000 0.0000 0.0000 Deck SIPLoad LS1 SIPFormworkStage 0.0000 0.0000 0.0150 0.0000 0.0000 0.0000 Girder Top Flange |
Add Comment