Roadway Alignment

Follow the below steps to create the alignment where the bridge will be located.

1	Go to Roadway Alignment.
2	Enter Start Station as 0.
3	Click the three-dots icon on the cell and Click Editor to define alignment properties.
4	Click + icon next to the Horizontal and add a circular segment.
5	Enter Length as 530 ft, Radius as 700 ft, and Direction as Towards Right.
6	Quick Tip You can edit the Vertical data such as grades and elevations of alignment in the Vertical tab. In this example, vertical data of alignment is set to 0.
7	Click + icon next to the Transverse to define the alignment cross-section at a specific station.
8	Enter the cross-section Station as 0 ft.
9	Enter the Left Edge to PGL distance as 20 ft. This distance is the length from the left edge to the centerline of the alignment.
10	Click + icon next to the At Sta+0 and add a section component.
11	Enter the Width as 50 ft and Slope as %-5.

Completed bridge alignment is illustrated below.