Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 3 Next »

Follow the below steps to add the insertion points where the bearings will be created

1

Go to Insertion Point on tree view next to the data spreadsheet.

2

Select a support line as Location.

3

Enter Transverse Offset to relocate the insertion point on the support line.

4
 Quick Tip

     Skew angle and transverse offset parameters for support lines that have skew > 0

Insertion point layout is given below

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.