Steel Tub Girder Bridge Design Reports [QG-6]

Access Steel Tub Girder Training Example

Please follow below instructions in order to access ‘Steel Tub Girder Training Example’

1	After logging in to your account, click on 'Project' located in the top right corner. Then, click on 'NEW' located in the top left corner of the screen.
2	Click on 'New Project' located under 'Steel Tub Girder Training Example' in the 'Example Project' section of the opened window.
3	After giving a name to the project, the example project will open.

Please follow below instructions in order to view Code Check Reports

1	Please make sure that the 'FEM' button in the top-middle of the screen is active. If the button is inactive, the 'Analysis' button will not appear. When the 'Analysis' button appears in the top left corner, click on it to start the analysis to initiate the finite element analysis (FEA) of the steel tub-girder bridge. This project's analysis takes approximately 3.5 minutes.
2	When the analysis is completed, click on 'Close' located in the bottom right corner of the analysis screen to exit the analysis interface.
3	Click on the 'Design' button that appears in the top left corner instead of the analysis button to calculate the parametric design parameters and collect the analysis results required for the corresponding design report. During the design process, you can track the design progress from the top-middle of the screen. You should keep the design tab visible until the task completes, as hiding or minimizing it pauses the process of collecting analysis results. The design process of this project takes approximately 9 minutes.
4	When the design run is completed, a summary pop-up will appear displaying the durations of the stages. Click on the "OK" button to start viewing the created design reports.
5	After the design run is completed, click on the 'Reports' button that appears in the top left corner, and then click on 'Detailed Report' to view the various design reports that have been set for the project.