Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 4 Next »

Follow the steps below to see the Slab Analysis Results

Table 1: Slab Analysis Result

1

Go to Slab Results under Analysis Result from tree view.

This checks whether changes have been made for each floor in the spreadsheet you have seen.

2

Go to 1st Floor under Slab Results.

Select the analysis result as Safe.


Select type and direction of the value want to see as a result, then the Result will drawn on the CAD side.

3
 CAD view

Analysis Source: Safe → Direction: Both → Type: Top Area

4

Select the analysis result as AECBolt.


Select result case, type and direction of the value want to see as a result, then the Result will drawn on the CAD side.

5
 CAD view

Analysis Source: Aecbolt → Result Case: Self Weight → Type: Fx

The Slab Analysis part is completed in this step.

You can proceed to the Design section.

  • No labels