Follow the below instruction to Run Tributary Analysis
Table 1: Tributary Analysis
| 1 | Go to Tributary under AEC|BOLT from tree view. I want to make the tributary Area Factors of C21 and C25 columns 1.1 instead of "1". I need the "Live Load Reduction" code for this, if this code is not imported, add it from Design Criteria. |  |
| 2 | Go to Tributary Correction Factors Tab at same spreadsheet. Set the "Tributary Area Factors" of columns C21 and C25 to 1.1 You can see Reducible Area on this spreadsheet. |  |
| 3 | Come back to Tributary Analysis Settings and Run Tributary |  |
Follow the below instruction to Run Slab Analysis
Table 2: Slab Analysis
| 1 | Go to 1st floor under Slab Analysis from tree view. Fill in the blanks in the spreadsheet according to your project. Press the "Run Mesh" button to check the mesh quality. |  |
| 2 | 
| |
| 3 | Click “Run Slab Analysis” button. After the analysis is complete, the Slab Analysis results is open |  |
| 4 | 
 
  
| |
| 5 | ||
| 6 | ||
Add Comment