Versions Compared

Version Old Version 6 New Version Current
Changes made by

mert.goktas

mert.goktas

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Info

Follow the steps Please follow below instruction to see the Slab Analysis Results

Table 1: Slab Analysis Results

1

Go Navigate to the "Slab Results" section under "Analysis Result from " in the tree view.

This checks whether section will allow you to check if any changes have been made for each floor in the spreadsheet that you have seenpreviously viewed.

2

Go Navigate to the "1st Floor" section under "Slab Results".

Select Once you have reached this section, please select "Safe" as the analysis result as Safe.

Select Then, select the type and direction of the value want you would like to see as a result, then the Result will drawn . After that the result will be displayed on the CAD side.

3
Expand
titleCAD view

Analysis Source: Safe → Direction: Both → Type: Top Area

4

Select "AECBolt" as the analysis result as AECBolt.

Select Then, select the result case, type and direction of the value want you would like to see as a result, then the Result will drawn . After that the result will be displayed on the CAD side.

5
Expand
titleCAD view

Analysis Source: Aecbolt → Direction: 1 → Result Case: Self Weight 1.2D+1.6L → Type: FxMz

Image RemovedImage Added

Tip

The Slab Analysis Results part is completed in this step.

You can proceed to the “Slab Design” section.