Modelling and drawings of the building are made under this main section.
...
Figure 1
| Show if | ||
|---|---|---|
| ||
Figure 1' de görülen Add butonuna tıkladıktan sonra Figure 2’de görülen ekranda oluşturulmak istenen kat sayısı girilir. |
Click “Add” button as shown in Figure 1 Within this section, you have the capability to generate modeling and plan drawings for the building.
...
→ Click the ”Add” button (Figure 1) to add stories and enter the number of stories as shown in (Figure 2).
...
...
Upon entering the total number of stories, a generic naming convention, and story numbers are automatically generated.
Figure 3
...
Parameters of the stories such as elevation can be edited after the stories are created.
Reference drawings that are uploaded in “Drawing Files” section can be assigned to stories as demonstrated in Figure 3.
Changes in a story which is assigned as “similar story” will affect other stories which uses data of that ”similar story” as shown in Figure 3.
...
| userGroups | Turkish |
|---|
Kat sayısı girildikten sonra gelen ekranda katlara ait property’ler güncellenebilir.
Drawing Files sekmesinde eklenen dosya çizimleri katlara assign edilmek isteniyorsa Drawing File sütunundan upload edilen dosya hangi kat için isteniyorsa seçilir.
...
tabulates the spreadsheet information specified below.
→ Enter the elevation of each story to automatically calculate the corresponding story height values, or enter the story height of each story to automatically calculate the corresponding story elevation values.
→ Optionally, select the drawing file for the story.
Uploaded drawing files must be assigned as the drawing file for a story in order to overlay the reference drawing.
→ Optionally, select the default material for the slab, column, and slab rebar for each story.
If default material parameters are set prior to modeling the story, the drawn slab, column, and rebar will automatically be assigned the default material properties.
→ Optionally, set a similar story.
CSI SAFE results of the story set as a similar story to another story will be used for the similar stories.
In Figure 4, the selected drawing file from the dropdown menu of the imported drawings (refer to Figure 3) is displayed. Additionally, the drawing file can also be selected from the corresponding dropdown menu of the individual story. The same concept applies to the default definitions of slab material, column material, and slab rebar material.
