Info |
---|
Follow the Please follow below instruction to Run Tributary Analysis |
Table 1: Tributary Analysis
1 | Go Navigate to the "Tributary" section under "AEC|BOLT from " in the tree view. I want would like to make change the tributary Area Factors of for columns C21 and C25 columns to 1.1 instead of their current value of "1". By increasing the correction factor for the tributary calculations, the results will be more conservative. If you want to take a more cautious approach, you can increase the correction factor further. In order to complete this task, I will need the "Live Load Reduction" code for this, if this code . If it is not already imported, please add it from the "Design Criteria" section. | |
2 | Go Navigate to the "Tributary Correction Factors Tab at " tab on the same spreadsheet. Set On this tab, please change the "Tributary Area Factors" of for columns C21 and C25 to 1.1You can see . Additionally, you will find the "Reducible Area" on this spreadsheet. | |
3 | Come back Please return to the "Tributary Analysis Settings and Run Tributary " section. Once you are there, please run the Tributary Analysis. |
...
Info |
---|
Follow the Please follow below instruction to Run AECBolt Slab Analysis. |
Table 2: Slab Analysis
1 | Go to Navigate 1st floor under Slab Analysis from tree view. Fill in the blanks in the spreadsheet according to your project.Press the with the correct information as per the project's specifications. After that please click on "Run Mesh" button to check the quality of the mesh quality. | ||||||
2 |
| ||||||
3 | Click “Run Slab Analysis” button. After After filling in the blanks and checking the mesh quality, please click the "Run Slab Analysis" button to perform the analysis. Once the analysis is completecompleted, the "Slab Analysis results is openResults" will be displayed. Here, you will be able to view the results for each load case.
| ||||||
4 |
| ||||||
5 | The results of the analysis can also be viewed in a browser. To do this, please navigate to the AEC|BOLT BIM Cloud page and press "Open". The most recent analysis performed in BDS will be displayed in the browser.
Once the browser page is open, please click the "FEA" button and run the Analysis. | ||||||
6 | |||||||
7 | After the analysis is complete, please open the "DATA" spreadsheet. Once the spreadsheet is open, please follow these steps in order: Select the "FEM" tab The sum value displayed will give the total self-weight analysis result for this slab |
Tip |
---|
The “Slab Analysis” part is completed in this step. You can proceed to the “CSI Safe Export & Import” section. |