Content Comparison

Navigate to Bridge Geometry > Insertion Point

Click the three-dots on the first cell of the Location and create the first insertion point by setting its location to Abut1

Precast girders Each bearing must have a starting and ending point. These points need to be determined along the road route.
There should be as many insertion points as there are girders from each support line to the other support line.
Additionally, an insertion point can be the beginning of one entry and the end of another, so it can be used jointly or notminimum of one insertion point. Additionally, for each precast girder, there should be one insertion point at the beginning and one at the end.

Since there are five girders from Abut1 support line to Pier1 support line, we need to define five insertion points at Abut1.

Enter To position the insertion point on the support line, input the Transverse Offset and Longitudinal Offset values as shown in the figure to relocate the insertion point on the support line.

Image RemovedImage Added

Repeat the same to create other insertion points and set their transverse offset values