| Info |
|---|
Follow Please follow the instructions provided below steps to perform Circular Column Design. |
Table 1:
...
Circular Column Design
| 1 | Go to C28 Navigate to the C17 (C18-C19) Circular column under the Column Design Line from the tree view. Click “Column Once there, click "Column Design Line Data” Data" and select “Axial "Axial Force Moment Design”Design". Enter the data as shown on the screenfigure. Please note that the "Reinforcement Ratio %" values have changed will change as a result of the entered values. |  | |||||
| 2 | Column C28
| ||||||
| 3 | Due to the entered values, Column C17 must be verified again due to the entered values. Click “Verify select” Please press the "Verify select" button and select C28 C17 column on the CAD side. If the Design State cell is shows "Passed" for all stories, the design process is complete. |  | |||||
| 34 | AlsoAdditionally, click by clicking on the Detailed Report "showShow" button for the Detailed Report, a code check report will be opened for column C28. | ||||||
| 45 |
| ||||||
Table 1: C 29 Circular Column Design
...
When you enter rebar count for circular column , BDS automatically determines the placement of the longitudinal rebar.
...
Go to C29 Circular column under Column Design Line from tree view.
Click “Column Design Line Data” and select “Rebar Templates”
Click “Draw Rebars” button and enter “2” inch.
Draw rebars as in CAD view as in
...
| Tip |
|---|
The “Circular Column Design” part is completed in this step. You can proceed to the “Beam Design” section. |