| Info |
|---|
Follow the steps Please follow below instruction to see the Slab Analysis Results |
Table 1: Slab Analysis
...
Results
| 1 | Go Navigate to the "Slab Results" section under "Analysis Result from " in the tree view. This checks whether section will allow you to check if any changes have been made for each floor in the spreadsheet that you have seenpreviously viewed. |  | |||||
| 2 | Go Navigate to the "1st Floor" section under "Slab Results". Select Once you have reached this section, please select "Safe" as the analysis result as Safe. Select Then, select the type and direction of the value want you would like to see as a result, then the Result will drawn . After that the result will be displayed on the CAD side. |  | |||||
| 3 |
| ||||||
| 4 | Select "AECBolt" as the analysis result as AECBolt. Select the Then, select the result case, type and direction of the value want you would like to see as a result, then the Result will drawn . After that the result will be displayed on the CAD side. |  | |||||
| 5 |
| ||||||
| Tip |
|---|
The Slab Analysis Results part is completed in this step. You can proceed to the “Slab Design” section. |