General
Girder: Specify the girder on which the stiffener will be generated.
Section: Assign a section for the stiffener. Sections can either be imported or assigned from previously defined ones under Properties > Sections.
Start Station: Specify the start station for the stiffener along the PGL.
End Station: Specify the end station for the stiffener along the PGL.
Transverse Offset from Mid. of Bottom Flange: Specify the transverse offset value for the stiffener’s location. When looking upstream along the PGL, negative values indicate the left side, while positive values indicate the right side. A value of zero indicates the centerline of the tub girder's bottom flange.
...