Versions Compared

Version Old Version 2 New Version 3
Changes made by

Melis Ceylan

Melis Ceylan

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info

To gather the related axial forces (specifically for the Strength Limit State),

1.Analyze the global model.

  1. Then, on the FEA tab, go to Composite Element Forces (Sectional).

image-20241130-110754.pngImage Removedimage-20241130-110754.pngImage Added

  1. Navigate to the relevant stage for which you are interested in the results. The results can be viewed for the Construction Stages,

image-20241130-110933.pngImage Removedimage-20241130-110933.pngImage Added

...or for Combination Cases, including LL cases, Composite/Non-composite cases, or for Limit States (max/min).

image-20241130-111112.pngImage Removedimage-20241130-111139.pngImage Removedimage-20241130-111112.pngImage Addedimage-20241130-111139.pngImage Added

  1. After specifying the case for viewing the reuslts , the result can be filetered to see onlt bootom flange results. For further clarification refer to video attached below.

    Results.mp4

  2. After specifying the case, the results at the position (station) where the access hole will be created can be obtained and applied to the access hole plate object.

image-20241130-112208.pngImage Removed

image-20241130-112208.pngImage Added

Plate: Specify the plate for which the analysis will be run.

Fx on Each Side: Specify the Fx force to be applied to the plate. Refer to the Info Panel above for further information on extracting the related axial force from the global model.