General
Girder: Specify the girder on which the transverse stiffener will be generated.
Station [ft]:
Lef Web Stiffeners Side:
Right Web Stiffeners Side:
Material:Start/End]: Users can specify the station of the stiffener either by selecting the Start/End options or by entering a station manually.
Left Web Stiffener Side [Both/Right/Left]: When looking upstation along the PGL, the left web of the selected girder can have the stiffener generated on the left side, the right side, or both sides of the web. This parameter specifies the side of the stiffener on the left web at the given station of the selected girder.
Right Web Stiffener Side [Both/Right/Left]: Similar to the left web, this parameter defines the side (both, right, or left) on which the stiffener will be placed for the right web.
Material: This parameter assigns a material to the stiffener. The material can either be imported or selected from previously defined materials.
Dimensions
Stiffener thickness [in]:Stiffener width [in]:Thickness: The thickness of the stiffener along the longitudinal direction can be specified using this parameter.
Stiffener Width: The width of the stiffener along the transverse direction can be specified using this parameter.
Distance from Top of Web [in]:: The top of the stiffener can be offset from the top of the web using this parameter.
Distance from Botttom Bottom of Web [in]: : The bottom of the stiffener can be offset from the bottom of the web using this parameter.
...
3D Detailing
Top -outer chamfer [in]:
Top-inner chamfer [in]:
Bottom-outer chamfer [in]:
Bottom-inner chamfer [in]:Outer Chamfer: For the top side of the stiffener, the chamfer value for the edge farthest from the web can be specified.
Top Inner Chamfer: For the top side of the stiffener, the chamfer value for the edge closer to the web can be specified.
Bottom Outer Chamfer: For the bottom side of the stiffener, the chamfer value for the edge farthest from the web can be specified.
Bottom Inner Chamfer: For the bottom side of the stiffener, the chamfer value for the edge closer to the web can be specified.
...