Content Comparison

🖱️ Click the three-dots icon on the Substructure cell, and then select Footing1.

As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the Section and Pile Properites are set in the next step.

🖱️ Click three-dots icon on the Pile Length/Section Data cell and click Edit.

🖱️Enter the Section Length as 50.

🖱️ Click three-dots icon on Start Section cell and select a the Section as PileCircle.

If you have reached this stage and you don't have a section to select, and if you want to use the Import Button, you can refer to the Quick Tip.

🖱️ Click three-dots icon on End Section cell and select a the Section as PileCircle.

If you have reached this stage and you don't have a section to select, and if you want to use the Import Button, you can refer to the Quick Tip.

🖱️Enter the Longitudinal Offset as 5.

🖱️Enter the Transverse Offset as 10.

🖱️Enter the Section Orientation as 30.

🖱️ Keep the Ground Elevation, Batter Angle(Long.), Batter Angle(Trans.) and Pile Embedment Embed. Length into Substructure as default.

You can edit the FE mesh settings of girders from FEA tab. 🖱️ Image Added Enter the Pile Capacity as 720.

Pile’s FEA propetries can be defined using FEA tab.

Image Added Keep Soil Spring Type as default.

Image Added Click three-dots icon on the Pile Properties cell and click Edit.

Soil Springs (Linear) cell and select the Section as PileCircle.

🖱️Enter the Offset from the bottom of the footing/bent as 3.

🖱️ Keep the Tx,Ty,Tz, Rx, Ry and Rz as default.

Image Removed

Image Added

🖱️ To model all the pile property, copy the data below and paste the parameters into the first cell in OpenBrIM spreadsheet.

🖱️ Enter the Pile Capacity as 360.

🖱️ Keep the Top Connection and Generate FEM as default.

🖱️ Set name as Pile2.

When the steps are completed, the shared screenshot displayed in the adjacent cell should be visible in the 3D view of OpenBrIM.