| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Follow the next steps to create load rating reports. |
...
Go to Load Rating/Steel I Girder Load Rating.
...
Under General column, name 1st column LoadRatReport.
...
Set G4 to Girder.
...
Enter Station input.
...
Set SIGLRT1 to LRTemplate.
...
Select Panel Type as Interior Panel.
...
Select Modular Ratio Comp. Method as EsbyEc.
...
Switch to Cover Plates.
...
Enter cover plate input data or keep the default values.
...
Switch to Section Losses.
...
Enter section loss input data or keep the default values.
| Tip |
|---|
Load rating report is completed. |
...
Go to Steel I Girder Load Rating under Load Rating on the tree view.
...
Copy General, Cover Plates and Section Losses from model inputs and paste into OpenBrIM.
...
Steel I girder Load Rating
...
General
| Code Block |
|---|
LoadRatReport G4 240.0000 SIGLRT1 Interior Panel EsbyEc N/A |
Cover Plates
| Code Block |
|---|
LoadRatReport 0.0000 0.0000 0.0000 0.0000 0.0000 0.0000 0.0000 0.0000 |
Section Losses
...
| Info |
|---|
After clicking on ‘Load Rating> Steel I Girder Load Rating' in the navigation treeview, follow the steps to define the Steel I Girder Load Rating. You can use the collapsed documentation page below for more information on the explanations of each parameter. |
| Expand | ||
|---|---|---|
| ||
| Steel I Girder Load Rating [SIG] |
| 1 |
|  | ||||||||||
| 2 | As a result of these operations, an issue will appear on the OpenBrIM screen. This does not necessarily mean that any operation was done incorrectly. The issue will be resolved when the load rating template is defined in the next step. |  | ||||||||||
| 3 |
| |||||||||||
| 4 |
|  | ||||||||||
| 5 |
|  | ||||||||||
| 6 |
|  | ||||||||||
| 7 |
|  | ||||||||||
| 8 |
|  | ||||||||||
| 9 |
|   | ||||||||||
| 10 |
|  | ||||||||||
| 11 | Proceed to the next step to verify the model. | |||||||||||
| Anchor | ||||
|---|---|---|---|---|
|
| Tip |
|---|
The completed steel i girder load rating is illustrated below. Please verify that you have the same model on your end by examining each view provided here. For more information on how to perform visual checks, refer to the quick tips. |
...
| Tip |
|---|
To view the entire procedure explained on this page, please watch the recorded Video below. |
...