This part is to inform about the general purposes of section definitions.
...
| Info |
|---|
Please follow the instructions provided below to set section definitions to be used in this bridge example. |
Step 1: Adding Sections to the Project
| 1 | Navigate to Properties > Sections |  |
| 2 | To import a section, click on the three-dot icon located on the first cell of the Name and select "Import Section". | |
| 3 | Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U78G5 Assign Material as: Fc_6ksi Select OpenBrIM Bridge Objects > Precast U Girder Sections > WS DOT > U54G5 Assign Material as: Fc_6ksi |  |
| 4 | Select OpenBrIM Bridge Objects > Basic Sections > Basic Shapes > Circle | 
|
| 5 | Enter Width & Depth as 42 in import section editor. Then Click Import | |
| 6 | Assign Material as Fc_5ksi (If the material Fc_5ksi is already assigned by default, there is no need to assign it again) | |
| 7 | Rename this section as EBSec | |
| 8 | Repeat the same steps from 4 to 7 for the other basic section. Enter Witdh and Depth
Rename this section as PCSec Assign Material as Fc_5ksi |  |
| 9 | Repeat the same steps from 4 to 7 for the other basic section.
Rename this section as ColSec Assign Material as Fc_6ksi |  |
| 10 | Repeat the same steps from 4 to 7 for the other basic section. Enter Witdh and Depth
Rename this section as PileSec Assign Material as Fc_4ksi |  |
