| Info |
|---|
Please follow the instructions provided below to add the insertion points where the bearings will be created. |
| 1 | Navigate to Bridge Geometry > Insertion Point |  | |||||
| 2 | To create the first insertion point, click on the three-dot icon located on the first cell of the Location. And click “Select” | ||||||
| 3 | From the combobox menu, choose the "SL1" support line for the End Bent location. |  | |||||
| 4 | For each support line, there should be one insertion point positioned beneath each "Concrete U Girder". Since there are two "Concrete U Girder" in the project, there will be two insertion points located on each support line. |  | |||||
| 5 | Enter Transverse Offset as -12 and +12 to relocate the insertion points on the support line |  | |||||
| 6 | Repeat the same to create other insertion points and set their transverse offset values | ||||||
| 7 |
| ||||||
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| 1 | Navigate to Insertion Point under Bridge Geometry. |
| 2 | Copy Bridge Parameters from model inputs and paste into OpenBrIM. |
...
| Tip |
|---|
Insertion point layout is given below. |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| Anchor | ||||
|---|---|---|---|---|
|
Insertion Point | |||||
|---|---|---|---|---|---|
Bridge Parameters | |||||
|