Content Comparison

1

→ Log in to your account and locate the 'Project' option in the top right corner.

→ Click on 'Project' and then select 'NEW' from the top left corner of the screen.

2

→ Under the 'Example Project' section, click on 'New Project' specifically located within the 'Precast I-Girder Training Example'.

3

→ Provide a name for your project and proceed to open the example project.

This quick guide provides a concise overview of the design reports presented on the right side of the screen.

Prestressed I-Girder Code Check

Pier Cap Code Check

Pier Column Code Check

Pier Footing Code Check

Pile Capacity Code Check

Please ensure that the 'FEM' button located in the top-middle of the screen is active. If the button is inactive, the 'Analysis' button will not appear.

Once the 'Analysis' button appears in the top left corner, it indicates that the FE model has been compiled and is ready for analysis.

→ Click on it to initiate the finite element analysis (FEA) of the precast I-girder bridge.

→ Once the analysis is completed, click the "Close" button to exit the analysis interface.

→ Proceed by clicking the "Design" button to calculate the parametric design parameters and collect the analysis results required for the design reports.

→ After the design run is completed, click on the "OK" button to start viewing the created design reports.

→ Clicking on the "Report" and "Detailed Report" buttons successively will display a range of design reports that can be accessed.

→ By clicking on the "Detailed Report" option, you will be able to access a diverse range of design outputs that provide:
i) specific reports, and
ii) code checks