Content Comparison

1

• Please make sure that the 'FEM' button in the top-middle of the screen is active. If the button is inactive, the 'Analysis' button will not appear.

• When the 'Analysis' button appears in the top left corner, click on it to start the analysis to initiate the finite element analysis (FEA) of the steel tub-girder bridge.

• This project's analysis takes approximately 3.5 minutes.

2

When the analysis is completed, click on 'Close' located in the bottom right corner of the analysis screen to exit the analysis interface.

3

• Click on the 'Design' button that appears in the top left corner instead of the analysis button to calculate the parametric design parameters and collect the analysis results required for the corresponding design report.

• During the design process, you can track the design progress from the top-middle of the screen.

• You should keep the design tab visible until the task completes, as hiding or minimizing it pauses the process of collecting analysis results.

• The design process of this project takes approximately 9 minutes.

Image Added

4

• When the design run is completed, a summary pop-up will appear displaying the durations of the stages.

• Click on the "OK" button to start viewing the created design reports.