Versions Compared

Version Old Version 16 New Version 17
Changes made by

Omer Faruk Ozkan

Omer Faruk Ozkan

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

1

  • After logging in to your account, click on 'Project' located in the top right corner.

  • Then, click on 'NEW' located in the top left corner of the screen.

2

Click on 'New Project' located under 'Steel Tub Girder Training Example' in the 'Example Project' section of the opened window.

3

After giving a name to the project, the example project will open.

View Design Reports of Steel Tub Girder Training Example

Info

Please follow below instructions in order to view Code Check Reports

1

  • When the 'Analysis' button appears in the top left corner, click on it to start the analysis to initiate the finite element analysis (FEA) of the steel tub-girder bridge.

  • This project's analysis takes approximately 3.5 minutes.

2

When the analysis is completed, click on 'Close' located in the bottom right corner of the analysis screen to exit the analysis interface.

3

  • Click on the 'Design' button that appears in the top left corner instead of the analysis button to calculate the parametric design parameters and collect the analysis results required for the corresponding design report.

  • You can monitor the design process from the top-middle of the screen.

  • You should keep the design tab visible until the task completes, as hiding or minimizing it pauses the process of collecting analysis results.

  • The design process of this project takes approximately 9 minutes.

4

Image Added

...