| Info |
|---|
Please follow the instructions provided below to create Girder Camber Diagram and Fabrication Model |
| 1 | Camber diagram is used in construction, which indicates the specified camber at all points along the length of a truss or beam. When constructing a structure, such as a bridge, fabrication models should be created that take into account displacements made along a line and their corresponding opposite shifts. This section will cover to create the Camber Diagram and Fabrication Model Report by making the required assignments. | |
| 2 | Navigate to Reports > Girder Camber Diagram and Fabrication Model |  |
| 3 | Set Girder under Girder Column to create Camber Diagram and Fabrication report. Set Girder as G1. | |
| 4 | Navigate Deflection Results Cases tab. | 
|
| 5 | Click three-dots icon on Steel Dead Load and click select. Select TubGirderDL in the combobox. | |
| 6 | Repeat the same steps from 4 to 5 for Non-Composite Dead Load and Composite Dead Load. Enter data as follows:
|  |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| 1 | Navigate to Girder Camber Diagram and Fabrication Model under Reports on the tree view. |
| 2 | Copy General and Deflection Result Cases from model inputs and paste into OpenBrIM. |
| Tip |
|---|
The Girder Camber Diagram and Fabrication Model have been created. |
...
| Insert excerpt | ||||||||
|---|---|---|---|---|---|---|---|---|
|
Girder Camber Diagram and Fabrication Model | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
General | Deflection Result Cases | ||||||||||
|
| ||||||||||