| Info |
|---|
Follow the next steps Please follow below instructions to add Stories to the BDS project. |
Table 1: Stories
| 1 | Go to Navigate 'Stories' from tree view. Click the 'Add' button and adding “1” floors. Enter 12 feet at , select '1' floor, and enter '12' feet for the elevation of the floor. |  |
| 2 | Enter Story Height value and Defult Materials Type data. |  |
| 3 | Set Assign the previously uploaded drawing file to 1st Floor. |
...
| Info |
|---|
Follow the steps Please follow below instructions to modelling the 1st floor. |
Table 2: Slab
| 1 | Go to 1st Floor below Stories from tree view. Click Overlay button and select checkbox below Xref drawing column. Then click OK. Check the drawing coming to Navigate the 1st floor under 'Stories' from the tree view, click the 'Overlay' button, select the checkbox under the 'Xref drawing' column, click 'OK', and verify the drawing on the CAD side." |  | |||||
| 2 |
| ||||||
| 3 | Go to Navigate 'Slabs' under the 1st Floor floor and click “Slab Edge” the 'Slab Edge' button. Draw the Slab Edge slab edge by following the overlayed drawing on the CAD side. In addition, Enter the thickness and clear cover values need to be entered." |  | |||||
| 4 | Click “Slab Piece” button. Draw the Slab Pieces by following the overlayed drawing on the CAD side. An elevation offset is given to the Slab piece according to Cad drawing. |  | |||||
| 5 |
| ||||||
| 6 | Click “Design Strip” button. Draw the Design Strip according to the direction you selection for Analysis. |  | |||||
| 7 |
| ||||||
| 8 | Click Refresh Parametric Model button. Then check that 3D view has been created. |  | |||||
| 9 |  | ||||||
...