| Info |
|---|
Follow the below instruction to making Run Tributary Analysis |
Table 1: Tributary Analysis
| 1 | Go to Tributary under AEC|BOLT from tree view. I want to make the tributary Area Factors of C21 and C25 columns 1.1 instead of "1". I need the "Live Load Reduction" code for this, if this code is not imported, add it from Design Criteria. |  |
| 2 | Go to Tributary Correction Factors Tab at same spreadsheet. Set the "Tributary Area Factors" of columns C21 and C25 to 1.1 You can see Reducible Area on this spreadsheet. |  |
| 3 | Come back to Tributary Analysis Settings and Run Tributary |  |
...
| Info |
|---|
Follow the below instruction to Run Slab Analysis |
Table 2: Slab Analysis
| 1 | Go to 1st floor under Slab Analysis from tree view. Fill in the blanks in the spreadsheet according to your project. Press the "Run Mesh" button to check the mesh quality. |  | |||||
| 2 |
| ||||||
| 3 | Click “Run Slab Analysis” button. | ||||||
