Versions Compared

Version Old Version 16 New Version 17
Changes made by

Zeynep Bayam

Dogukan Kilic

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

1

Go to Bridge Geometry > Insertion Point

2

Click the three-dots on the first cell of the Location and create the first insertion point by setting its location to Abut1

3

Enter Transverse Offset as -16.5 to relocate the insertion point on the support line

4

Repeat the same to create other insertion points and set their transverse offset values

5
Expand
titleQuick Tip: Skew angle & Offset parameter calculation

Skew angle and transverse offset parameters for support lines that have skew > 0. User need to enter T value for skewed supports.

Skew angle and longitudinal offset parameters for support lines that have skew > 0.

Support Lines ( Normal - Offset ) in the figure are parallel. However longitudinal offset parameter for insertion points does not keep their assigned support line orientation. Insertion points are relocated with respect to the imaginary support line at “offset” distance away.

...