Versions Compared

Version Old Version 13 New Version 14
Changes made by

Orkun Gülel (Unlicensed)

Zeynep Bayam

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Info

Follow the below steps to add the insertion points where the bearings will be created.

1

Go to Insertion Point on tree view next to the data spreadsheet.

2

Select a support lineas Location.Click the three-dots on the first cell of the Location and create the first insertion point by setting its location to Abut1

3

Enter Transverse Offset to relocate the insertion point on the support line.

4
Expand
titleQuick Tip

Skew angle and transverse offset parameters for support lines that have skew > 0.

Skew angle and longitudinal offset parameters for support lines that have skew > 0.

Image RemovedImage Added

Support Lines ( Normal - Offset ) in the figure are parallel. However longitudinal offset parameter for insertion points does not keep their assigned support line orientation. Insertion points are relocated with respect to the imaginary support line at “offset” distance away.

...