Versions Compared

Version Old Version 5 New Version 6
Changes made by

Orkun Gülel (Unlicensed)

Orkun Gülel (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Info

Follow the below steps to add the insertion points where the bearings will be created.

1

Go to Insertion Point on tree view next to the data spreadsheet.

2

Select a support lineas Location.

3

Enter Transverse Offset to relocate the insertion point on the support line.

4
Expand
titleQuick Tip

     Skew angle and transverse offset parameters for support lines that have skew > 0.

5

Follow the steps below to match the same inputs as illustrated model.

6

Go to Insertion Point under Bridge Geometry.

7

Copy Bridge Parameters from model inputs and paste into OpenBrIM.

Tip

Insertion point layout is given below.

Anchor
ModelInputs
ModelInputs

Expand
titleQuick Tip

Copy the desired data with the automatic copy button in the upper left corner.

Click on the first cell in and use the Ctrl+V shortcut to paste.

Insertion Point

Bridge Parameters

Code Block
IP1	Abut1	0	-16.5
IP2	Abut1	0	-5.5
IP3	Abut1	0	5.5
IP4	Abut1	0	16.5
IP5	Pier2	0	-16.5
IP6	Pier2	0	-5.5
IP7	Pier2	0	5.5
IP8	Pier2	0	16.5
IP9	Pier3	0	-16.5
IP10	Pier3	0	-5.5
IP11	Pier3	0	5.5
IP12	Pier3	0	16.5
IP13	Abut4	0	-16.5
IP14	Abut4	0	-5.5
IP15	Abut4	0	5.5
IP16	Abut4	0	16.5