SD(1st Floor or Roof)

Figure 1

Click “Design Strip” button as in Figure 1 to draw directions for layers. When direction1 is drawn direction2 which is perpendicular to it will be drawn automatically as illustrated in Figure 2. These directions are assigned to layers by default but can be edited later as demonstrated in Figure 3.

Figure 2

Figure 3

Click “Shear Wall Coner Zones” at spreadsheet as in Figure 1.

Click “Generate Corner Zones” button as in Figure 4 to generate zones in shear walls for generation of stresslines .

Click “Draw Corner Zone” button as in Figure 4 to create zones manually for stressline generation.

Figure 4

Click “Stress Lines” at spreadsheet as in Figure 1.

Click “Run Stress Line Generation” button as in Figure 4 or Figure 5 to generate stress lines on slab.

Figure 5

Click “Draw Stress Line” button as in Figure 5 to draw stress lines manually. Edges of stress lines must be on columns or corner zones of shear walls.

Generated stress lines can be deleted if not necessary.