Sleeper Slab [SIG]

For the modeled approach slabs, sleeper slabs can be modeled as a separate object using this object of the workflow.

General

Approach Slab: This parameter can be used to specify the approach slab for which the sleeper slab will be modeled.

Longitudinal Offset: This parameter can be used to define the offset in the longitudinal direction for the sleeper slab. A value of 0 will place the sleeper slab with its center at the downstation-start section of the approach slab. A positive value will offset the sleeper slab in the upstation direction.

Material: This parameter can be used to assign a material to the sleeper slab. Materials can be selected from previously defined options under Properties-Materials or imported as needed.

Length: This parameter can be used to specify the length of the sleeper slab in the longitudinal direction. For a visual representation, refer to the figure provided below.

Width: This parameter can be used to specify the width of the sleeper slab in the transverse direction. For a visual representation, refer to the figure provided below.

Thickness: This parameter can be used to specify the thickness of the sleeper slab in the vertical direction.For a visual representation, refer to the figure provided below.