For modeled abutments, approach slabs can be modeled as a separate object using this object of the workflow.
General
Abutment: This parameter specifies the abutment for which the approach slab will be modeled.
Longitudinal Offset: The offset value for the approach slab in the longitudinal direction can be specified using this parameter. Approach slabs will be generated at the location where the chosen abutment's abutment wall starts. A negative value will indicate offsetting the approach slab in the downstation direction, while a positive value will offset the approach slab in the upstation direction.
Material: A material can be assigned to the approach slab from either previously defined options under Properties-Materials or imported as needed.
Start Skew: The skew angle at the start of the approach slab (the downstation section) can be defined using this parameter.
End Skew: The skew angle at the end of the approach slab (the upstation section) can be defined using this parameter.
Length: The length of the approach slab in the longitudinal direction can be specified using this parameter. For a visual representation, refer to the figure provided below.
Width: The width of the approach slab in the transverse direction can be specified using this parameter. For a visual representation, refer to the figure provided below.
Thickness: The thickness of the approach slab can be defined using this parameter.For a visual representation, refer to the figure provided below.
0 Comments