Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 7 Next »

For this object to be utilized, the model must have completed the analysis and successfully passed the design process, as this object will use the data obtained from the analysis and extract the results of the design.

This component divides each span into 10 segments and reports the major axis bending moment, lateral bending moment, and shear at each location.

Girders: Select the girders for which you wish to view the results.
Factored Results: Select the load combination table that includes unfactored analysis result cases and their corresponding factors, as well as the limit states.
Ignored Insertion Points for Span Positioning: Usually, no selection is needed in this section as the span definitions are automatically determined by the object using the connected insertion points, which represent the bearing locations. However, if some of the connected insertion points are not bearings and instead represent temporary supports, they should be selected and marked as ignored.

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.