Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 2 Current »

Users may want to ensure the stability of girders during the analysis of girder erection. Girders that are not connected with bracings may be unstable. To address this issue, the girders are supported at temporary support locations, and this element can be utilized for this purpose.

General

Insertion Point: Pick or Select an insertion point to define the location of the single element.

Girder: Select the girder to be supported.

Flange [Top Left/Top Right]: This parameter specifies the flange as either Top Left or Top Right. The terms "right" and "left" indicate directions when looking up-station along the PGL.

Station: Specify the station location where the temporary support will be generated between the insertion point and the selected girder flange.

Vertical Offset (from top): Define the top boundary of the temporary support using this parameter, which specifies its top location.

Section: Assign a section to the support with this parameter. Sections can either be imported or selected from previously defined options.

Girder End Release

Tx [kip/in]:

Ty [kip/in]:

Tz [kip/in]:

Rx [kip-in/rad]:

Ry [kip-in/rad]:

Rz [kip-in/rad]:

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.