Concrete Girder Code Check [PIG]

General

Code Check Template: This parameter can be used to specify the code check template to be used for the girder’s code check. A previously defined code check template can be assigned using this parameter.

Girder: Specify the girder for which the code check will be performed.

Design Section w Rebars (or Tendons) [Override Section/Section from 3D]: Users can specify whether the code check will be performed according to the section that is visible in 3D or if a new section will be overridden to perform code checks accordingly.

Override Design Section (Noncomposite): If the "Design Section w Rebars (or Tendons)" parameter is defined with the option "Override Section," the new section definition can be made using this parameter. The section that will override a previously defined one can be assigned from a previously defined section under Properties > Sections or can be imported. Otherwise, if the "Design Section w Rebars (Tendons)" parameter is defined with the option "Section from 3D," this parameter will not be applicable.

Stages for Stress Checks:

• Stage: This parameter can be used to specify the stage at which stress values will be checked.

• Loss Computation Time Frame [Segment Erection/Between Transfer and Deck Placement/After Deck Placement]:

• Tendon Stress Check [Immediately prior to transfer/At service limit state after all losses/Prior to seating/At anchorages and couplers immediately after anchor set/Elsewhere along the length of the member away from anchorages and couplers immediately after anchor set/At service limit state after losses]:

• Compression Check [0.65f'ci/0.45f'c/0.6f'c]:

• Tensile Stress Limit:

Station: This parameter can be used to specify the station at which the code check will be performed.

Relative Position (readonly): The relative position of the code check station based on the total length of the girder will be presented to the user.

Effective Web Width:

Shear Reinforcements

Shear Reinforcement Data [From 3D/User Input]:

Rebar Profile:

Rebar Spacing:

Number of Legs:

Transverse Rebar Material: